We are all familiar with the old and traditional way of cleaning our driveways. We can clearly say that it is one big work with so much time and effort. However, have you ever considered pressure washing?

Pressure washing is an excellent way to clean a concrete driveway, and transform an old, worn-out surface into a new-looking, clean, and pristine driveway. Whether it is residential or commercial pressure washing, it is important to take care to pressure wash the right way, to avoid damaging the concrete. We at Lawrenceville Pressure Washing Pros can help you with every pressure cleaning service that you need. With our professional individuals, we are sure that we can do the work done properly and orderly.

Furthermore, for you to have some overview on how to clean concrete driveways using pressure washer, here’s the steps:

Step 1: Preparations

While it may be tempting to jump right in and start blasting away, it is important to first properly prepare your driveway and any surrounding areas. Large debris and dirt clumps should be swept and cleaned up first, as pressure washing is not an ideal way to remove these, and they will quickly be in the way. Any structures such as walls or painted surfaces should also be covered, as the water pressure could damage and chip them. A tarp is a great choice for covering more sensitive surroundings.

You will also want to prepare the concrete by decreasing it. Special degreasers are available that work well to remove stains and other imperfections. Use a stiff brush to give the concrete a good scrubbing.

Step 2: Pressure Washing

Now that the concrete has been prepared, it is time to actually pressure wash. Choose the correct tip for your pressure washer for concrete. Doing the first wash at low pressure and using a detergent is the best way to really clean the surface. Starting at low pressure helps to make sure that you do not chip or damage the concrete. Overlap each pass by a few inches to make sure it is covered, and go over the entire driveway with detergent. Once you have done this, use higher pressure and pure water to even pass over the driveway to rinse detergent, and finish cleaning the surface.

Step 3: Sealant

The final step is to seal your concrete driveway. The sealant helps to protect against future stains, and some also are water-resistant, making water clump and run off easier, rather than sit and pool. After the concrete has been sealed, it should not be used for at least 24 hours.

These are the basic steps to the best way to pressure wash your commercial or residential concrete driveway. Of course, if this sounds like too much work, you can always contact a professional pressure washing contractor just like us to do all of your pressure washing needs.